Mendota M27 - O Remove Door

85-03-01120 M27 Page 49
4.8 TO REMOVE DOOR
Use the glass latch tool to disconnect the spring latches from the glass frame. Insert tool into hole in latch, pull towards you and
rotate 180-degrees to disengage top latches. Remove tool. There are four spring latches on this gas fireplace. Always make
certain the hook glass latches are in the inverted position after removing the glass frame. This inverted latch position will make
it easier to reinstall the glass frame later.
With both hands, rotate top edge of glass frame away from unit, approximately 8”.
Lift glass frame up 1”, at an angle, and move away from unit.
Door is now free from unit.
NOTE: Always check glass gasket condition and gasket seal any time the glass door is removed and when
reinstalling glass door.