Operator's manual – Page 45
6 Controls
6.1 Main switch
The main switch (A) is located at the rear to the right of
the engine support. If the machine is not to be used for
a prolonged period, switch it off so that the batteries are
disconnected from all consumersThe diagram shows the
main switch in the OFF position. To switch it on, it has to
be turned 90° clockwise.If the machine is not to be used
for a prolonged period, switch it off so that the batteries are
disconnected from all consumers.
6.2 Emergency shut down switch
The Emergency shut down switch (4) shuts the machine down immediately
in an emergency situation. The Emergency shut down switch must be reset
before the machine can be restarted. Do this by turning it clockwise.
Before resetting the Emergency shut down switch, ensure that
restarting the machine will not pose any risk.
6.3 Ignition lock
The diagram shows the ignition lock (1) in the idle marked position.
Turning the ignition key clockwise to the first setting switches on the
ignition. The next setting is the glow plug preheat position, which
is not required on this machine since preheating is automatic on
demand. To start the machine, the ignition key must be turned again
until it stops. Keep the ignition key turned until the diesel engine starts.
Release the key immediately and leave in this position. When you want
to switch the engine off, return the ignition key to its original position.
The engine cannot be started if the ignition key was originally turned to
the glow plug preheat position and then allowed to return to the
ignition position. Switch off the ignition and turn the key again to the engine start position.
To Next Page
Loading...
