Oil filter - engine 102 (example)
1 Center bolt
2 Oil filter cover
64
- Replace filter element and sealing ring.
- Position cover while paying attention to proper seating of the gasket,
turn in and tighten nuts.
Observe tightening torque.
Engine 102
- Prior to removing the oil filter , place oil catch pan under oil filter housing.
- Loosen but do not unscrew oil filter cover center bolt.
- Pull off cover from oil filter housing in order that the oil may drain.
- Unscrew center bolt and remove cover.
- Renew filter element and all sealing rings.
- Position cover while paying attention to proper seating of the gasket,
turn in and tighten center bolt.
Observe tightening torque .
Engine 601/602/102
- Screw in and tighten oil drain plug. Observe tightening torque.
- Fill engine with oil.
- Start engine and idle for a short while. Observe oil pressure indicator light. The
indicator light must go out after a few seconds .
- Shut off engine.
- Check oil filter and oil drain plug for leaks.
- Check engine oil level and top up oil to the upper dipstick mark.
"
I
To Next Page
Loading...
