Starter Motor Will Not Crank the Engine (Electric Start Models)
POSSIBLE CAUSES
•
Blown 15‑amp fuse in the starting circuit. Refer to Maintenance section.
NOTE: Reverse battery connection will blow the 15‑amp fuse.
• Outboard is not shifted to neutral position.
• Weak battery or battery connections are loose or corroded.
• Ignition key switch/start button failure.
• Wiring or electrical connection faulty.
• Starter motor or starter solenoid failure.
Engine Will Not Start
POSSIBLE CAUSES
• Lanyard stop switch not in RUN position.
•
Incorrect starting procedure. Refer to Operation section.
• Old or contaminated fuel.
• Fuel is not reaching the engine.
• Fuel tank is empty.
• Fuel tank vent not open or restricted.
• Fuel line is disconnected or kinked.
• Primer bulb not squeezed.
• Primer bulb check valve is faulty.
•
Fuel filter is obstructed. Refer to Maintenance section.
• Fuel pump failure.
• Fuel tank filter obstructed.
• Ignition or electronic fuel injection system component failure.
•
Spark plugs fouled or defective. Refer to Maintenance section.
Engine Runs Erratically
POSSIBLE CAUSES
• Low oil pressure. Check the oil level.
•
Spark plugs fouled or defective. Refer to Maintenance section.
• Incorrect setup and adjustments.
• Fuel is being restricted to the engine.
a.
Engine fuel filter is obstructed. Refer to Maintenance section.
b. Fuel tank filter obstructed.
c. Stuck antisiphon valve located on permanently built in type fuel tanks.
d. Fuel line is kinked or pinched.
TROUBLESHOOTING
eng 103
To Next Page
Loading...
Need help?
General