EasyManuals Logo

Mercury 20 EFI FourStroke User Manual

Mercury 20 EFI FourStroke
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
4. Route the oil filter drain hose into an approved container.
a - Drain hose storage location
b - Drain hose
5. Remove the oil filter by turning the filter counterclockwise. If necessary,
carefully move wires temporarily out of the way, to gain clearance for the
oil filter wrench.
6. Wipe up any spilled oil.
7. Clean the mounting base. Apply a film of clean oil to the filter gasket. Do
not use grease. Install the new filter. When the gasket contacts the base,
tighten the filter an additional 3/4 to 1 turn.
8. If any components were moved or removed to gain access to the oil filter,
restore them to their original positions or install them accordingly.
DRAINING THE ENGINE OIL
1. Lock the outboard in the full tilt up position.
2. Position the outboard so the drain hole is facing downward.
3. Remove the drain plug and drain the engine oil into an appropriate
container.
IMPORTANT: Do not use a crankcase oil pump when changing the oil or
engine damage may occur.
4. After the initial oil has been drained, temporarily install the drain plug.
Disengage the tilt lock and lower the outboard. Wait a minute to allow the
remaining oil that was trapped in the engine to return to the drain. Return
the outboard to the full tilt position and drain the remaining oil.
a
b
64179
MAINTENANCE
eng 89

Table of Contents

Other manuals for Mercury 20 EFI FourStroke

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 20 EFI FourStroke and is the answer not in the manual?

Mercury 20 EFI FourStroke Specifications

General IconGeneral
BrandMercury
Model20 EFI FourStroke
CategoryEngine
LanguageEnglish

Related product manuals