12. Attach the interlock cable to the shift arm, and temporarily secure the cable to the starter bracket with the two jam nuts.
a - Jam nuts
b - Interlock cable anchored in the shift arm
13.
Install the shift and throttle cables. Refer to Section 1D ‑ Remote Wiring Harness and Control Cable Installation.
14. Install the recoil starter and air box.
• It is easiest to install the recoil starter and air box together.
•
Refer to Section 8A ‑ Recoil Starter Installation and Section 3C ‑ Air Box Installation.
15. Adjust the interlock cable jam nuts to remove any slack in the cable.
16.
Install the starboard driveshaft housing cover. Refer to Section 5A ‑ Driveshaft Housing Covers.
Throttle and Shift Linkage
Page 7A-14 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017
To Next Page
Loading...
