Typical SmartCraft Dual Outboard Installation 2002 MY
1. 8-Pin Harness from Port Outboard
2. Digital Sensor Harness Extension Port Outboard
3. Digital Speedometer Sensor Port Outboard
4. Digital Trim Sender Port Outboard
5. Digital Sensor Harness Extension Port Outboard
to 6-pin Digital Sensor Harness
6. 6-pin Digital Sensor Harness Port Outboard (Only
if Duel Fuel and Oil Tanks are Used)
7. Digital Connections for Fuel Sender
8. Digital connections for Oil Sender
9. Weather Proof Cap for 6-Pin Harness
10. Weather Proof Cap for System Link Gauges
11. 2-1/4 in. System Link Gauges (Fuel, Temp, Trim,
etc.) Port Outboard
12. System Tachometer Port Outboard
13. System Speedometer
14. System Tachometer Starboard Outboard
15. System Link Series Connections Port Outboard
16. 10-Pin Control Area Network (CAN) Connection to
System Tachometer Port Outboard
17. Connections for Auxiliary Warning Horn for Depth
Sensor
18. Ambient Air Temperature Sensor
19. 10-Pin Control Area Network (CAN) Connection to
System Speedometer
20. Connections for GPS
21. Connections for Auxiliary Warning Horn for Depth
Sensor
22. 10-Pin Control Area Network (CAN) Connection to
System Tachometer Starboard Outboard
23. System Link Series Connections Starboard Out-
board
24. 2-1/4 in. System Link Gauges (Fuel, Temp, Trim,
etc.) Starboard Outboard
25. Weather Proof Cap for System Link Gauges
26. 10-Pin Control Area Network (CAN) Connection
from System Tachometer Port Outboard to Junc-
tion Box
27. 10-Pin Control Area Network (CAN) Connection
from System Speedometer to Junction Box
28. 10-Pin Control Area Network (CAN) Connection
from System Tachometer Starboard Outboard to
Junction Box
29. 10-Pin Control Area Network (CAN) Junction Box
30. 10-Pin Control Area Network (CAN) Connection
from Junction Box to Port Outboard 10-Pin Data
Buss CAN Harness
31. 10-Pin Control Area Network (CAN) Connection
from Junction Box to Starboard Outboard 10-Pin
Data Buss CAN Harness
32. Resistor in Port CAN Harness (120Ω 1/4W 5%)
33. Yellow Resistor Identifier on Harness End
34. 10-Pin Control Area Network (CAN) Connection
from Junction Box to Port Outboard 10-Pin Data
Buss CAN Harness
35. 10-Pin Data Buss CAN Harness Port Outboard
36. 3-Pin Data Buss CAN Connection for Power
37. Resistor in Port CAN Harness (120Ω 1/4W 5%)
38. Yellow Resistor Identifier on Harness End
39. 10-Pin Control Area Network (CAN) Connection
from Junction Box to Starboard Outboard 10-Pin
Data Buss CAN Harness
40. 10-Pin Data Buss CAN Harness Starboard Out-
board
41. 3-Pin Data Buss CAN Connection for Power, Must
be Disconnected and Capped on Dual Installation
42. Digital Trim Sender Starboard Outboard
43. Digital Speedometer Sensor Starboard Outboard
44. 8-Pin Harness from Starboard Outboard
45. Digital Sensor Harness Extension Starboard Out-
board
46. Digital Sensor Harness Extension Starboard Out-
board to 6-pin Digital Sensor Harness
47. 6-pin Digital Sensor Harness Starboard Outboard
48. Digital Connections for Fuel Sender
49. Digital connections for Oil Sender
50. 4-Pin Digital Sensor Harness Connection to
Paddle Wheel
51. Paddle Wheel/Lake/Sea Water Temperature
Sender
52. Weather Proof Cap for Junction Box Terminal
To Next Page
Loading...
Need help?
General