Mercury 200 VERADO Installation Manual

200/225/250/275 VERADO 4-STROKE
90-10238051 Page 13 / 51
3. Ensure O-ring seals are in place on end of steering helm fittings.
a
b
ob01460
a - O-ring seals (4) b - Plug - not used
4. Make the hose connections to the steering helm as shown. Use a thin wrench and
hold the helm fittings from turning while tightening hoses. Do not over-tighten the hose
connections.
a
P
T
ob01461
R STAR
L PORT
b
c
d
e
a - Thin wrench
b - Helm hex fitting wrench size (P & T) - 19 mm (3/4 in.)
c - Helm hex fitting wrench size (R & L) - 16 mm (5/8 in.)
d - Hydraulic hose hex fitting wrench size (P & T) - 21 mm (13/16 in.)
e - Hydraulic hose hex fitting wrench size (R STAR & L PORT) - 18 mm
(11/16 in.)
Helm Fitting ID Mark Hose ID Mark Description
P P Pressure from pump to helm
T T Tank low pressure return to pump

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat