Mercury 200 VERADO Installation Manual

200/225/250/275 VERADO 4-STROKE
90-10238051 Page 35 / 51
• Ensure the wiring harness connected to the command module will reach all the
connection points.
3691
a
b
c
c
a - DTS command module
b - Clamp or cable tie
c - CAN link harness
Battery Information
!
CAUTION
Hex nuts must be used to secure battery leads to battery posts to avoid loss of electrical
power.
• Do not use deep cycle batteries. Engines must use a marine starting battery with 1000
MCA, 800 CCA or 180 Ah.
• When connecting engine battery, hex nuts must be used to secure battery leads to
battery posts. Torque nuts to specification.
Description Nm lb. in. lb. ft.
Hex nuts 13.5 120
IMPORTANT: Battery cable size and length is critical. Refer to engine installation manual
for size requirements.

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat