Mercury 200 VERADO Installation Manual

200/225/250/275 VERADO 4-STROKE
90-10238051 Page 17 / 51
Electrical Connections to the Steering Pump
NOTE: For single engine installation, the power steering pump battery cables should be
connected directly to the outboard starting battery.
+
-
a
b
c
d
e
f
g
h
i
j
k
4250
b
Single Engine Application
a - Engine
b - Battery cable
c - DTS power harness
d - Battery
e - Power steering fuse - 90 Amp
f - Power steering pump 12V positive
harness
g - Power steering pump
h - Driver module
i - Power steering pump ground
harness
j - Power steering signal harness
k - Engine signal harness

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat