Mercury 200 VERADO Installation Manual

200/225/250/275 VERADO 4-STROKE
Page 16 / 51 90-10238051
2. Position the 90° hose fittings to the desired direction. Loosen fastening nuts in order
to rotate. Position fittings and re-tighten fastening nuts.
b
c
ob01465
a
a - Position fittings
b - 90° fitting
c - Straight fitting
3. Remove and discard the shipping caps from the two fittings on the steering cylinder.
Ensure O-ring seals did not lift off with shipping caps.
4. Ensure O-ring seals are in place on end of each fitting.
a
a
ob01466
a - O-rings
5. Make the hydraulic steering hose connections to the steering cylinder as shown.
ob01467
L
P
O
R
T
R
S
T
AR
a
b
a - Port fitting (L PORT) b - Starboard fitting (R STAR)

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat