Mercury 200 VERADO Installation Manual

200/225/250/275 VERADO 4-STROKE
Page 50 / 51 90-10238051
WITHOUT DRILLING HOLE THROUGH TRANSOM (OPTIONAL)
Route the cable over the transom or through a drain hole that is above the water line.
ob01510
a
b
c
d
e
a - Splash well drain hole
b - Cable cap
c - Cable clamp
d - Paddle wheel assembly
e - Distance between first cable clamp and top of paddle wheel - 25.4 mm
(1.0 in.)
Installing and Removing the Paddle Wheel
Installation - Slide the pins into the slots in the bracket and snap the tabs into place.
Removal - squeeze open (unlock) the tabs and pull on the paddle wheel.
a
b
ob01511
a - Tabs b - Pins
Wiring Connections
IMPORTANT: Before making wire connections, make sure wires are routed through the
transom.

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat