Mercury 200 VERADO Installation Manual

200/225/250/275 VERADO 4-STROKE
90-10238051 Page 51 / 51
NOTE: Wires can only be pushed into the connector one way. Align the wire terminal with
the tabs inside the connector. Have the wiring routed through the transom. Push each
wire terminal into its respective location in the connector. Push wire in until they snap into
place. Secure wires into connector with the wire retainer.
A A
B B
C C
D D
A A
B B
C C
D D
a
b
b
W H T
Y E L
B L U
B L K
ob01512
a - Connector b - Wire retainer
Template - Paddle Wheel Speed Sensor
a
b
ob01513
a - Drill holes here
b - Align dotted line with the transom bottom edge and fold under

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat