Mercury 40/50 Series - Page 59

INSTALLATION
49
3. Detach the throttle and shift cable joints by removing the cotter
pins.
a - Throttle cable
joint
b - Cotter pin
c - Washer
d - Shift cable joint
e - Washer
f - Cotter pin
4. Thread at least 15 mm (0.59 in.) of the remote control cables
through the terminal eyes. Securely lock the terminal eyes with
the locknuts.
a - Cable joint
5. Move the remote control lever Forward (F), to Neutral (N), and
to Reverse (R) to confirm the shift is working; then set the lever
to Neutral (N).
38310
a
b
c
d
e
f
38311
15 mm (0.59 in.)
a