EasyManuals Logo

Mercury 40/50 Series User Manual

Mercury 40/50 Series
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #82 background imageLoading...
Page #82 background image
FUEL AND OIL
72
2. Turn off the ignition switch, and fill up the oil tank with
recommended engine oil.
3. Start the engine, and shift into gear carefully.
4. Confirm that the indicator lamp goes out and the buzzer does
not sound.
Replenishing the oil in the engine oil tank:
1. Open the oil fill door on the top cowl.
2. Remove the oil tank cap.
3. Fill up the tank with genuine engine oil or recommended oil.
a - Recommended
engine oil
b - Oil fill door
c - Oil tank cap
IMPORTANT: Please follow the instructions below.
1. In the unlikely event that gasoline is filled into the oil tank by
mistake, drain the oil tank completely, and consult an
authorized service shop for advice.
2. Check the amount of oil in the oil tank visually before starting
the engine.
Oil pump air vent
Visually check whether there is air in the oil through the oil line
connecting the oil tank with the oil pump. If present, purge the air
as follows:
38323
a
b
c

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 40/50 Series and is the answer not in the manual?

Mercury 40/50 Series Specifications

General IconGeneral
BrandMercury
Model40/50 Series
CategoryOutboard Motor
LanguageEnglish

Related product manuals