Section 4 - Maintenance
90-8M0113924 eng DECEMBER 2015 Page 49
2. Remove the dipstick. Wipe clean and install fully into the dipstick tube. Wait 60 seconds to allow trapped air to vent.
a - Oil dipstick handle
b - Operating range
3. Remove the dipstick and observe the oil level. Oil level must be in the operating range. Install the dipstick into the dipstick
tube.
Filling
IMPORTANT: Do not overfill the engine with oil.
IMPORTANT: Always use the dipstick to determine the exact quantity of oil required.
1. Remove oil fill cap.
a - Oil fill cap
2. Add the specified engine oil to bring the level up to, but not over, the operating range mark on the dipstick. Check the oil
level.
3. Replace the fill cap.
All Models
Capacity Fluid Type
Engine oil (with filter) 6.5 Liter (7 US qt)
Mercury 25W‑40 Synthetic Blend 4‑Stroke
Engine Oil
Engine Oil and Filter
Replace the oil filter at every oil change.
See Maintenance Schedule for the change interval. Engine oil should be changed before placing the boat in storage.
IMPORTANT: Change engine oil when the engine is warm from operation. Warm oil flows more freely, carrying away more
impurities. Use only recommended engine oil (refer to the Specifications section).
To Next Page
Loading...
Need help?
General