RIGHT HAND NON-RATCHETING
90-855347R1 JANUARY 1999 Page 6A-19
c. If reverse gear bearing remains attached to reverse gear, install Universal Puller
Plate (91-37241) and position puller plate, gear and bearing on a press with gear
side down. Use a suitable mandrel and press gear out of bearing.
51874
a
b
a-Universal Puller Plate
b-Mandrel
d. If reverse gear bearing has remained in bearing carrier, use slide hammer to re-
move bearing in the same methods as was used to remove reverse gear (Step
“b”).
3. Propeller shaft oil seals can be removed by (a) using a pry bar, or (b) pressing seals
out when propeller shaft needle bearing is pressed out of bearing carrier.
4. If inspection of propeller shaft needle bearing determines that replacement of bearing
is required, use Universal Bearing Removal and Installation Tool (91-31229A1) to
press bearing and seals out of bearing carrier.
NOTE: Reverse gear must be removed from bearing carrier before propeller shaft needle
bearing can be removed.
51871
b
c
d
51868
a
a-Pry Bar
b-Propeller Shaft Needle Bearing
c-Mandrel
d-Oil Seals
To Next Page
Loading...
Need help?
General
