MAINTENANCE
88
7. Remove the tube from the oil fill/drain hole and quickly install
the sealing washer and the oil fill/drain screw. Tighten
securely.
8. Add specified gear lube to the monitor bottle.
9. When oil starts to run out of the oil vent hole of the drive,
re‑install the oil vent screw and sealing washer. Tighten
securely.
a - Gear lube monitor bottle
Tube Ref No. Description Where Used Part No.
87
High Performance
Gear Lubricant
Gear lube monitor 92-802854A1
10.Continue adding gear lube to the monitor bottle until the oil
level is at the "FULL" line mark on the bottle.
11.Lubricate the O‑ring on the bottle neck with sterndrive oil to
ensure ease of installation and removal of the cap.
12.Install the filler cap, and be careful to not overtighten.
IMPORTANT: Re‑check the reservoir bottle oil level after the first
use.
To Next Page
Loading...
