Your router should support WPS. Otherwise, please refer to Using
Your Web Browser (Mobile UI) or Using Your Web Browser (PC UI)
1 Power On
Plug the extender into a power outlet near your router, and the Signal LED
turns solid red.
2 Connect
1) Press the WPS button on your router.
2) Within two minutes, press the WPS button on your extender. The Signal
LED should change from flashing to a solid state, indicating a
successful WPS connection.
If the Signal LED does not change from flashing to solid,
please refer to Using Your Web Browser (Mobile UI)
or
Using Your Web Browser (PC UI).
Some ISP gateways disable the WPS function by default.
If the WPS method fails, please refer to
Using Your Web
Browser (Mobile UI) or Using Your Web Browser (PC UI).
3 Relocate
Plug the extender into a power outlet about halfway between your router
(Host Network) and the Wi-Fi dead zone. The location you choose must
be within the range of your existing host network
Wait until the Signal LED is lit and solid green. If it is orange, relocate the
extender closer to or farther away from the router to achieve a better
signal quality.
Enjoy!
The extender uses the same wireless network name (SSID) and password as
your host network.