Introduction 2
Button Explanation
The buttons are located on the bottom panel.
WPS Button: If your wireless router supports WPS or QSS function, you can
press the WPS or QSS button on your router and then press the WPS button
on your extender to establish a secure connection between the wireless
router and the extender.
Reset Button: This button is used to restore the extender to its factory
default settings.
To reset the extender:
With the extender powered on, use a pin to press and hold the Reset button
for more than 5 seconds until the Signal LED starts blinking quickly, then
release the button and wait the extender to reboot to its factory default
settings.
Position the Extender
For safety and best performance, we suggest that you position the extender
vertically as shown below.
To Next Page
Loading...
