DSP5000 AND DSP5000C
8
Unpacking
Before you begin installation you should ensure that your DSP
loudspeakers are the correct voltage for your local AC supply. If they are
not, do not try to install them, and contact your dealer.
You should not make any connections to the DSP loudspeakers, or to any
other component in your system, while the AC power supply is connected
and switched on.
Care when unpacking
Take great care when unpacking or repacking the DSP loudspeakers that
you do not put undue pressure on the face containing the drive units, as
they may be damaged if pressed.
Components
Each pair of DSP loudspeakers is supplied with the following components:
•
The DSP loudspeakers complete with grilles.
•
A hex wrench (3mm) for the drive units.
•
Eight screw-in spikes with lock nuts and protectors together with a
wrench for fi tting them (DSP5000 only).
•
Eight rubber bumpons (DSP5000C only).
•
MSR+ remote, battery and user guide.
•
One power cord per speaker.
•
Meridian M5 lead (8m).
•
Meridian S5 lead (8m).
•
This user guide.
If any of these items is missing please contact your dealer. We suggest that
you retain the packaging carefully for maximum protection in transit.
To fi t the feet (DSP5000 only)
The feet ensure that the loudspeakers have a stable base, and can be
adjusted to allow for uneven fl oors. Use the spikes for carpeted fl oors; they
are designed to penetrate the pile without damaging or fl attening the
carpet. Use the protectors for solid fl oors.
Each DSP loudspeaker needs four feet, fi tted as follows:
• Fit a lock nut to each foot, leaving about 2mm of thread between the
lock nut and foot.
• Screw each foot into the threads on the bottom of the loudspeaker. Do
not fully tighten the lock nut at this stage.
To Next Page
Loading...
Need help?
General
