Meridian DSP User Manual

CONFIGURING THE DSP
LOUDSPEAKERS
57
When confi guring the
DSP loudspeakers, point the remote at
the speakers, even if you have a Meridian
Surround Controller.
Configuring the setup options
The setup options allow you to adjust the frequency
response of the loudspeakers to compensate for their
position. You only need to confi gure the master
loudspeaker.
To select Setup mode
• Turn off the DSP loudspeaker using the power switch on the back panel.
• Turn on the power again while holding down the Store key on the
remote.
The display will show:
Setup
It will then revert to standby: .
You can now operate the speaker in the usual way, using the additional
setup menus to adjust the response while listening to sources.
When you have fi nished adjusting the setup options:
• Switch off at the back panel, and then switch on again to restore normal
operation with the setup you have programmed.
To adjust the frequency response
• Press Function > or Function < until the display shows the current
response setting.
For example:
Free
• Press Function A or Function V to select the appropriate option as
follows:
Option What it means
Free
Flat frequency response.
Boundary
Speaker closer than 0.5m (20") to a wall.
Sub.1
Applies a second-order high-pass fi lter at 80Hz for
use with an analogue subwoofer.
Sub.2
Applies a second-order high-pass fi lter at 120Hz
for use with an analogue subwoofer
Corner
Speaker closer than 0.5m (20") to a corner.

Meridian DSP Specifications

General

Brand	Meridian
Model	DSP
Category	Speakers
Language	English