CONFIGURING THE DSP
LOUDSPEAKERS
55
Configuring the sources
When the master DSP loudspeaker is set to one of the standard Types the
12 source selection keys on the remote select inputs D1 and D2 as shown in
the table on page 52.
If the confi guration you want is not catered for by one of the standard
settings, you can confi gure each source individually.
The DSP loudspeakers provide 12 sources corresponding to the 12 source
selection keys on the remote:
CD, RADIO, DVD, AUX, DISC, TAPE, TV, CABLE, SAT, VCR1, VCR2, and
GAME.
For each source you can confi gure:
•
The label used for it on the front panel display, from a range of
alternative labels.
•
The digital input it selects.
•
The comms type and address, to control other Meridian 500 Series
equipment.
•
Other advanced options.
You only need to confi gure the sources on the DSP loudspeaker you have
specifi ed as the master.
To confi gure a source
While in confi guration mode:
• Press the source key on the remote corresponding to the source you
want to confi gure.
For example, to confi gure the Radio
source the display initially shows:
RD Radio
• Press > or < to step between options.
The right-hand set of characters shows the current value of the option.
• Press A or V to change the value of the option.
When you have fi nished programming sources:
• Switch off at the back panel, and then switch on again to restore normal
operation.
To Next Page
Loading...
Need help?
General
