DSP5200 AND
DSP5200HC
14
Unpacking
Before you begin installation you should ensure that your DSP
loudspeakers are the correct voltage for your local AC supply. If they are
not, do not try to install them, and contact your dealer.
You should not make any connections to the DSP loudspeakers, or to any
other component in your system, while the AC power supply is connected
and switched on.
Care when unpacking
Take great care when unpacking or repacking the DSP loudspeakers that
you do not put undue pressure on the face containing the drive units, as
they may be damaged if pressed.
Components
Each pair of DSP loudspeakers is supplied with the following components:
•
The DSP loudspeakers complete with grilles.
•
A hex wrench (3mm) for the drive units.
•
Eight screw-in feet with retractable spikes (DSP5200 only).
•
Eight rubber bumpons (DSP5200HC only).
•
MSR+ remote, battery and user guide.
•
One power cord per speaker.
•
Meridian M5 lead (8m).
•
Meridian S5 lead (8m).
•
This user guide.
If any of these items is missing please contact your dealer. We suggest that
you retain the packaging carefully for maximum protection in transit.
Caution
Meridian Audio has taken every care in the design, assembly, fi nishing and
packing of this product. Some models include a high-gloss fi nish, which is
achieved by painting up to fi ve coats of polyester lacquer onto the
plywood, each one hand polished.
Due to the product size and high technology cabinet construction, small
marks on the lacquer surface may be visible when unpacked. These small
marks can usually be removed as described in Cleaning, page 62.
It is the nature of all lacquer fi nishes to shrink over time. This is
unavoidable and may result in cabinet joint lines becoming visible.
To Next Page
Loading...
Need help?
General
