42
TROUBLESHOOTING
A.3 FCC COMPLIANCE
The following FCC statement applies to the Em50, Em50R, Em50G, DataStation, and Rm-1.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
The Em50R, DataStation, and Rm-1 contain one of the following modules:
• FCC ID: OUR9XSTREAM IC: 4214A-9XSTREAM
• FCC ID: OUR-24XSTREAM IC: 4214A 12008
The Em50G contains the following module:
• FCC ID: IHDT56HQ1 IC: 109O-HQ1
Information for users:
Changes or modifications to the EM50 series loggers not expressly approved by METER
Group, Inc. USA could void FCC compliance and thus the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
There is no guarantee that a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, we encourage users to attempt to correct the interference by trying
one or more of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult METER Customer Support or your local representative for support.
To Next Page
Loading...
Need help?
General
