25.6.2009 Rev. 3.0
Operation instructions
10
Cleaning of external surfaces of the door
The external glass of the door can be opened for cleaning. Unscrew the two screws shown
in the picture and turn the external glass carefully downward until it stays fully open.
Spray diluted detergent solution onto the door’s metal surfaces between the glasses and
onto the glass surfaces. Let the detergent work for about 15 minutes. Wipe the loosened
dirt and detergent carefully with a damp cloth. After cleaning, return the external glass to
its former position. Fit the screws in place and tighten carefully.
4.3.2 How to change the oven bulb
To change the burnt lamp, do the following:
• Let the oven cool so that you can put your bare hand inside the oven without burn-
ing it.
• Ensure that the oven is switched off. All controls should be in the 0 position.
• Unscrew the lens of the oven lamp using your fingers.
• Pull the lamp out of the socket.
• Put a new lamp into the socket. Lamp type: OSRAM Halogen lamp 300°C G9
230V 25W.
• Fit the lens in place and tighten slightly.
Use of the appliance is strictly prohibited if the lens of the oven lamp is broken or not
properly in place.
Do not overtighten the lens after replacement of the lamp.
4.3.3 Other service measures
This appliance does not contain parts which can be serviced by the user. Maintenance
must be carried out by an authorised agent.
In the event of fault or malfunction, switch the appliance off at the mains. Use an agent
authorised by the manufacturer and original spare parts.
To Next Page
Loading...
