7.7.2008 Rev. 3.0
Operation instructions
7
Weekly cleaning
Spray diluted detergent solution into the inside of the proving cabinet, and on the inside
surface of the door. Heat the proving cabinet to about +50ºC (not essential), switch off at
the mains and let the detergent work for about 15 minutes. Use a brush or cleaning pad to
scrub the burnt places. Avoid the use of steel wool and abrasive pads and use chemical
cleaners instead of mechanical ones. Once a surface is scratched, dirt sticks to it much
more easily.
Wipe the loosened dirt and detergent carefully with a damp cloth. After washing, dry the
proving cabinet by heating at +60ºC for 5 minutes.
After cleaning the inside of the proving cabinet, wipe the outside surfaces, knobs and
handrail.
Cleaning the guide rails
When cleaning the proving cabinet thoroughly, loosen, soak and wash the guide rails. The
rails can be easily removed and conveniently washed in a dishwasher.
To remove the guide rails:
• Lift the guide rails upwards.
• Pull the guide rails towards the centre of the inside of the proving cabinet.
• Lift the guide rails out of the proving cabinet.
• Replace the guide rails in the reverse order.
Cleaning of external surfaces of the door
The external glass of the door can be opened for cleaning. Unscrew the two screws shown
in the picture and turn the external glass carefully downward until it stays fully open.
Spray diluted detergent solution onto the door’s metal surfaces between the glasses and
onto the glass surfaces. Let the detergent work for about 15 minutes. Wipe the loosened
dirt and detergent carefully with a damp cloth. After cleaning, return the external glass to
its former position. Fit the screws in place and tighten carefully.
To Next Page
Loading...
