7.7.2008 Rev. 3.0
Installation
9
5. Installation
5.1 General
The installation of this appliance must be carried out in accordance with the manufactur-
er’s instructions and in compliance with local rules and regulations. These instructions
must be used together with the installation drawing.
This appliance may be connected to the mains electricity by qualified persons only.
5.2 Transporting and unpacking the appliance
The appliance is best transported in its own package, which protects it from outside dam-
age. Should it be necessary to remove the appliance from its package, the appliance,
which is on a support base, must be moved by lifting by the intermediate bearers of the
base. To prevent damage, the top of the appliance must not be used as a worktop during
installation.
5.2.1 Fastening the appliance to the stand
Standard ovens/proving cabinets delivered separately are fastened to the stand with the
help of the installation kit supplied with the appliance.
Prior to fastening the stand, remove the adjustment screws (4 pcs.) located on the appli-
ance bottom. The screws come loose by turning by hand. Fasten the stand as shown in the
illustration below, using the components 1, 2 and 3.
1. Fixing screw, 4 pcs
2. Washer, 4 pcs
3. Hexagon screw, 4 pcs
4. Chef oven/proving cabinet
5. Stand
21
4
3
5
To Next Page
Loading...
