MI 3109 EurotestPV Lite Safety and operational considerations
11
2.3 Standards applied
The EurotestPV Lite instruments are manufactured and tested in accordance with the
following regulations:
Electromagnetic compatibility (EMC)
Electrical equipment for measurement, control and laboratory
use – EMC requirements
Class B (Hand-held equipment used in controlled EM environments)
Safety requirements for electrical equipment for measurement, control
and laboratory use – Part 1: General requirements
Safety requirements for electrical equipment for measurement, control
and laboratory use – Part 2-030: Particular requirements for testing
and measuring circuits
Safety requirements for electrical equipment for measurement, control
and laboratory use – Part 031: Safety requirements for hand-held
probe assemblies for electrical measurement and test
Safety requirements for electrical equipment for measurement,
control, and laboratory use - Part 2-032: Particular requirements for
hand-held and hand-manipulated current sensors for electrical test
and measurement
Electrical safety in low voltage distribution systems up to 1000 V
AC
and 1500 V
AC
– Equipment for testing, measuring or monitoring of
protective measures
Part 1 General requirements
Part 2 Insulation resistance
Part 4 Resistance of earth connection and equipotential
bonding
Part 10 Combined measuring equipment
Reference standard for photovoltaic systems
Grid connected photovoltaic systems – Minimum requirements for
system documentation, commissioning tests and inspection
Crystalline silicon photovoltaic (PV) array – On-site measurement of
I / V characteristics
Note about EN and IEC standards:
Text of this manual contains references to European standards. All standards of
EN 6XXXX (e.g. EN 61010) series are equivalent to IEC standards with the same
number (e.g. IEC 61010) and differ only in amended parts required by European
harmonization procedure.
To Next Page
Loading...
Need help?
General
