Calibrateur multifonctions CX 1651
Manuel de l'utilisateur 107
Entry of the value using cursor buttons
• press <, >, ∧ or ∨ button. The display now includes cursor marks which point to the active digit.
• ∧ and ∨ buttons can be used to change the active digit. <, > buttons can be used to change the
position of the cursor marks
• to get to the default screen, press EXIT button or keep pressing the center cursor button until there
is no [ _ _ _ _ _ _ _ ] under any value. All values can be set using the buttons or the potentiometer.
Entry of the value using the potentiometer
• press the potentiometer knob. The display now includes cursor marks which point to the active digit
• turn the knob to change the active digit
• press the potentiometer knob to change to the mode which allows to change the value of the active
digit. ← and → symbols are displayed above the active digit. Active digit can be changed by
turning the knob.
• turn the knob to change back to the mode which allows to change the position of the active digit.
• to get to the default screen, keep pressing the center cursor button until there is no [ _ _ _ _ _ _ _ ]
under any value, or press EXIT button. All values can be set using the buttons or the potentiometer.
Reverse polarity
In DC voltage and DC current modes, the polarity of the output value can be reversed by pressing +/- display
button. „ - “ symbol appears in front of the main data value.
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
Need help?
General
