Calibrateur multifonctions CX 1651
Manuel de l'utilisateur 135
Zeroing function can be used e.g. to compensate the voltage drops at the cables, to suppress any remanent value
of the signal etc.
Notes:
* The current inputs of the multimeter are protected from current overloading by a fuse located in 140-41
cable adapter. The fuse can be replaced after turning the cap of the fuse holder. The procedure is
described in the adapter’s manual.
* The multimeter can be used as a DC milivoltmeter with 20 mV, 200 mV, 2 V, 10 V ranges. The
appropriate input terminals are PTHU and PTLU.
* Maximum allowed voltage on the input terminals against ground terminal is 20 V.
* Frequency measurement is possible up to 15 kHz. Input signal must be within 0.2 to 5 V range.
squarewave or pulse shape of the input signal is expected.
Overloading can damage the multimeter.
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
Need help?
General
