Calibrateur multifonctions CX 1651
100 Manuel de l'utilisateur
The function of the potentiometer can usually be performed by the cursor buttons. The central button is used to
confirm the selection (ENTER).
4 Numeric keyboard
The keyboard allows the entry of numeric values on the display. The central button is used to confirm the
selection (ENTER). CANCEL button can be used to cancel the entry.
5 Function buttons
Function buttons can be used to call-up the functions of the calibrator directly. The following buttons are
provided:
function button
DC voltage U / DC
AC voltage U / AC
DC current I / DC
AC current I / AC
resistance / capacitance R – C
power / energy P – E
frequency F
internal multimeter METER
simulation of temperature sensors T
After the function mode is changed, the parameters of the respective function are restored. If the respective
function was never used, the calibrator resets to its reference values. Reference values for individual functions are
listed below.
function value parameters
DC voltage 10V - -
AC voltage 10 V f = 1000 Hz
DC current 100 mA - -
AC current 100 mA f = 1000 Hz
resistance
100 kΩ
capacitance
1 µF
power 100 W f = 100 Hz
*1
energy
frequency 1000 Hz U = 1 Vsym
multimeter 10 V DC voltage
simulation of temperature sensors 100
o
C Pt 100/1.385, ITS90
cold junction temperature of TC sensors 23
o
C R
*1
U = 100 V, I = 1 A, PF(power factor) = 1 LA, active power is displayed in Watts
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
Need help?
General
