Metrohm 930 Compact IC Flex Manual - Short Instructions

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Installation
930 Compact IC Flex ChS/PP/Deg (2.930.1360)
￭￭￭￭￭￭￭￭
19
For pre-rinsing, you will need the holder for the eluent aspiration fil-
ter (6.2744.360), a syringe and the purge needle (6.2816.040).
This procedure can also be found in the video "Inserting a new aspi-
ration filter" at the following link: ic-help.metrohm.com
2
Mounting aspiration filter
NOTE
Always wear gloves when handling the aspiration filter.
￭ Place the loose end of the eluent aspiration tubing into the aspira-
tion filter.
The end of the tubing should reach approximately to the center of
the aspiration filter.
￭ Tighten the aspiration filter to the filter holder.
Figure 4
Installing tubing weighting and aspiration filter
4.6 Connecting the eluent degasser
The eluent degasser is completely connected. No installation work is
required.

Metrohm 930 Compact IC Flex Specifications

General

Brand	Metrohm
Model	930 Compact IC Flex
Category	Laboratory Equipment
Language	English