￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
930 Compact IC Flex ChS/PP/Deg (2.930.1360)
￭￭￭￭￭￭￭￭
III
Table of contents
1 About these short instructions 1
2 Introduction 2
2.1 Instrument description ......................................................... 2
2.2 Intended use ......................................................................... 4
2.3 Safety instructions ................................................................ 4
2.3.1 General notes on safety ........................................................... 4
2.3.2 Electrical safety ........................................................................ 4
2.3.3 Tubing and capillary connections ............................................. 5
2.3.4 Flammable solvents and chemicals ........................................... 6
2.3.5 Recycling and disposal ............................................................. 6
2.4 Symbols and conventions .................................................... 6
3 Overview of the instrument 8
3.1 Front ...................................................................................... 8
3.2 Rear ...................................................................................... 10
4 Installation 12
4.1 Setting up the instrument .................................................. 12
4.1.1 Packaging .............................................................................. 12
4.1.2 Checks .................................................................................. 12
4.1.3 Location ................................................................................ 12
4.2 Capillary connections in the IC system ............................. 12
4.3 Removing transport locking screws .................................. 13
4.4 Connecting the drainage tubing and leak sensor ............ 15
4.4.1 Installing the drainage tubing ................................................ 15
4.4.2 Connecting the leak sensor .................................................... 16
4.5 Connecting the eluent bottle ............................................. 17
4.6 Connecting the eluent degasser ........................................ 19
4.7 Installing the high-pressure pump .................................... 20
4.8 Installing an inline filter ..................................................... 20
4.9 Installing the pulsation absorber ...................................... 20
4.10 Injection valve ..................................................................... 20
4.11 Metrohm Suppressor Module (MSM) ............................... 20
4.11.1 Inserting the rotors ................................................................ 21
4.11.2 Connecting the Metrohm Suppressor Module (MSM) ............. 22
To Next Page
Loading...
Need help?
General
