4.17 Connecting the instrument to the power grid
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
30
￭￭￭￭￭￭￭￭
930 Compact IC Flex ChS/PP/Deg (2.930.1360)
4.17 Connecting the instrument to the power grid
WARNING
Electric shock from electrical potential
Risk of injury by touching live components or through moisture on live
parts.
￭ Never open the housing of the instrument while the power cord is
still connected.
￭ Protect live parts (e.g. power supply unit, power cord, connecting
socket) from moisture.
￭ Unplug the power plug immediately if you suspect that moisture has
gotten inside the instrument.
￭ Only personnel who have been issued Metrohm qualification may
perform service and repair work on electrical and electronic parts.
Connecting the power cord
Accessories
Power cord, three-core with IEC 60320 instrument plug type C13. Con-
ductor cross-section 1 mm
2
/ 18 AWG. Power plug according to customer
requirement (6.2122.XX0).
Do not use a not permitted power cord.
1
Plugging in the power cord
￭ Plug the power cord into the instrument's power socket.
￭ Connect the power cord to the power grid.
4.18 Initial start-up
Even before the guard column and separation column are installed, the
entire system must be completely rinsed with eluent for the first time.
To Next Page
Loading...
