Metrohm NIRS DS2500 - Default Chapter; Table of Contents

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
￭￭￭￭￭￭￭￭
III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.2 Intended use ......................................................................... 2
1.3 About the documentation ................................................... 2
1.3.1 Symbols and conventions ........................................................ 2
1.4 Safety instructions ................................................................ 3
1.4.1 General notes on safety ........................................................... 3
1.4.2 Electrical safety ........................................................................ 3
1.4.3 Flammable solvents and chemicals ........................................... 4
1.4.4 Recycling and disposal ............................................................. 4
2 Overview of the instrument 5
2.1 Front ...................................................................................... 5
2.2 Rear ........................................................................................ 6
3 Installation 7
3.1 Unpacking and inspecting the instrument ......................... 7
3.1.1 Packaging ................................................................................ 7
3.1.2 Checks .................................................................................... 7
3.1.3 Scope of application ................................................................ 7
3.2 Setting up the instrument .................................................... 7
3.2.1 Ambient conditions ................................................................. 7
3.2.2 General conditions .................................................................. 8
3.2.3 Vibrations and shocks .............................................................. 8
3.3 Connecting the power supply cable .................................... 8
3.4 Connecting the data cable ................................................. 10
3.5 Switching on the instrument ............................................. 11
3.6 Initial start-up ..................................................................... 12
3.7 Setting up accessories ........................................................ 15
3.7.1 Inserting the sample cup for granulated substances ............... 15
3.7.2 Inserting the sample cup for powders .................................... 16
3.7.3 Inserting the sample cup for liquid samples ............................ 17
4 Control 18
5 Operation 19
6 Maintenance 20
6.1 Maintenance by Metrohm Service .................................... 20