Meyer 9100 BOSS RT - Page 34

Meyer Manufacturing Corporation - 34 - 9100RT
Weekly or every 25-30 loads (Oil Bath Hubs):
• Check the oil level in each wheel hub (Item 3). The oil should be 1/2”
high in the sight glass (Item 4). If low, add EP80/90 gear lube through
the pop out rubber plug (Item 5) at the center of the hub.
Every 100-150 loads:
• Apply oil to the four (4) rear gate latch pivot bolts (Item 6).
NOTE: Double doors will have two (2) rear gate latch pivot
bolts.
• Lubricate the six (6) double door locations (if equipped).
3
5
4
Rear Gate Latch Pivot Bolt Locations
6
6
6
6
Double Door Lubrication Locations
7