Operating Modes
Manual-Mode
This operation mode is preset ex factory.
If Manual Mode is turned on and Record-Mode is
selected, accents and flams can be programmed,
as well samples be selected.
Step-Mode
Unlike Manual-Mode if Step-Mode is turned on and
Record-Mode is selected. Parameter changes for
individual steps can be set here (Parameter lock).
First, select the step to be edited (LEDs flash
red). Save the parameter setting by pressing the
INSTRUMENT/SEL(Select)key.
To change the parameters for all preset steps and
not only for one, press the Shift key in
combination with the INSTRUMENT/SEL(Select) key.
T4.!G*33!9*,E!/)1!*,+/2.5/*4,+!942!+G*/5)*,B!=1/G11,![0,.03!0,E!S/1-![4E1!.,E12!
S)*9/!].,5/*4,+7!
()1!Q1,/*4,1E!S1V.1,512
To Next Page
Loading...
