LFOs
Press the LFO key to turn on an LFO track. The
parameters shown in the display shown, Rate and
Amount, can be adjusted using the encoders DATA1
and DATA2.
The waveform can be changed by using of the DATA3
key and the first eight white keys (see list
below).
The DATA4 key selects the modulations target of
the LFO. In most cases, this is the tune
parameter.
Mute LFOs
Enter the Mute-LFO mode by pressing the LFO key
while holding down the shift-key. The LED above
the LFO-key is now lit green. The respective LFOs
can now be muted using instrument keys.
Please note! Instruments with alternative tracks
such as Clap and Perc1 only have one LFO each.
To Next Page
Loading...
