Knob Recording
Parameter movements of currently selected
instruments can be recorded (Motion Record).
The knob record function is only usable if Step-
Mode is selected, and Record-Mode being turned on:
• Make sure Record-Mode is turned on. If this
is not the case, please refer to page 10.
• Push the Knob-Record key.
• The LED flashes red until the current pattern
starts again.
• Recording starts if the LED glows red until
the end of the pattern (depending on how many
bars are turned on).
• All parameter movements can be recorded while
the LED is glowing red.
Accent
The accent always corresponds to the set accent
level. A total of four accent levels are
selectable. To change accents Record-Mode needs to
be turned on. Changes to the preset accent level
affects all steps that have been selected for
editing as well as newly set steps.
Follow these instructions to change the Accent:
• Press the Accent key
• The LED goes out (Level 1)
• Press again
• The LED lights up green (Level 2)
• Press again
• The LED lights up red (Level 3)
• Press again
• The LED lights up green/red (Level 4)
To Next Page
Loading...
