Sequencer-Modes (Pattern Programming)
There are two different sequencer modes available
to program(record/write) a pattern: Manual-
Trigger-Mode and Record-Mode.
Manual-Trigger-Mode
The LED of the MAN TRG/RECORD key lights up green.
While the sequencer is not running, instruments
can be triggered by the corresponding keys
(prelisten). They are shown in the display with
two additional parameters that can be adjusted via
the DATA1 and DATA2 encoders.
Selection of Instruments
While the sequencer is stopped, press a
corresponding instrument key (the instrument is
shown in the display).
However, this does not happen while the
sequencer is running. While the sequencer is
running, press the INTRUMENT/SEL key in
combination with the corresponding instrument
key to be shown in the display.
(4!05/.033A!!21542E!/)1!/2*BB121E!*,/2.Q1,/+!G)*31!/)1!+1V.1,512!*+!2.,,*,B!Real*
Time*Note*Record*Mode!,11E+!/4!=1!05/*>0/1E7!!()1!*,+/2.5/*4,+!4,!)4G!/4!
To Next Page
Loading...
