ABS fault warning indicator
When the vehicle is powered on, the
ABS warning lamp will briefly
illuminate to show that the system is
self-checking and that the lamp is
functioning. It should turn o after a
few seconds.
Consult the nearest JSW MG
authorised service center if:
1. The lamp does not light up when
the vehicle is powered on.
2. The lamp stays on continuously.
3. The lamp lights up while driving,
indicating a potential ABS fault.
Although the vehicle can operate
normally without ABS, it's strongly
recommended to have the ABS
inspected and repaired as soon as
possible.
4-35
ABS
CAUTION
An illuminated ABS warning lamp
may signal that the braking system
is not functioning properly. If the
brakes are not in good working
condition, it can lead to collisions,
personal injuries, and damage to
your vehicle or other property.
NOTE
In case of indication
continuously ON. Do not drive
the vehicle in this condition. Get
the ABS module of vehicle
checked. Get the vehicle
checked, contact JSW MG
authorised service center.
!
4
INSTRUMENT PANEL
C o m f o r t & C o n v e n i e n c e
To Next Page
Loading...
