2
S a f e t y S y s t e m s
2-40
BRAKE SYSTEM
Emergency brake*
In case of an emergency requiring
rapid deceleration when the braking
eect is insuicient, you can pull up
the electronic parking brake switch
upward for additional braking
assistance.
To activate the emergency brake
function, release the electronic
handbrake switch to cancel the
emergency brake function.
Do not use the emergency brake
function in non-emergency
situations. This function is for
emergency only and will wear the
brake disc and brake caliper.
WARNING
!
Shifting to P (Park) while the
vehicle is in motion may cause
you to lose control of the vehicle.
After the vehicle has stopped,
always make sure the vehicle is in
P (Park), apply the parking brake,
and turn the vehicle o.
When parking on an incline, shift
the gear to P (Park) and apply the
parking brake to prevent the
vehicle from rolling downhill.
c. Automatic vehicle hold (AVH)
fault working indicator*
After the vehicle is powered on, if the
AVH fault warning lamp illuminates
for several seconds and then goes
out, it indicates that the warning lamp
and AVH function module work
normally.
In case of an automatic vehicle hold
function module fault or a warning
lamp fault, it will be indicated in any of
the following ways:
• When the power supply is on, the
lamp remains o.
• After lighting up, it does not go
out.
keep illuminated during driving Once
the automatic vehicle hold (AVH) fault
warning lamp shows the above
abnormalities, please contact the
JSW MG authorised service center in
time.
A
To Next Page
Loading...
