4-39
Tire Pressure Monitoring System
(TPMS) Fault Indicator
When the tire pressure is low, this
indicator stays on; when the TPMS
fails, this indicator flashes for a
period of time and then stays on.
(In case of a direct tire pressure
monitoring system, when the tire
pressure is too high, the indicator
will also be normally on). Please
timely check and adjust the air
pressure.
For the correct tire pressure, please
refer to “Technical data".
NOTE
In case of indication
continuously ON. Check the tire
pressure in all 4 tires. Get the
vehicle checked. Contact JSW
MG authorised service center.
!
Direct tire pressure monitoring
system*
As shown in the figure, a direct TPMS
can display corresponding tire
pressure value on the instrument.
After the vehicle has been driven for
a period, it will update the
dashboard display information
based on the collected data.
Indirect Tire Pressure Monitoring
System does not display tire
pressure values and has a reset
switch on the vehicle console to
distinguish.
4
INSTRUMENT PANEL
C o m f o r t & C o n v e n i e n c e
To Next Page
Loading...
