MG Windsor EV - Page 196

Battery removal
Turn o the ignition switch and all
electrical appliance before removing
the battery.
To remove the battery, you should
first remove the negative cable, next
the positive cable, and then remove
bolts on the battery retaining
bracket, finally remove the battery.
Battery replacement
Please go to the JSW MG authorised
service center to remove and refit
the battery. Only fit MG
recommended battery while
replacement to maintain the correct
vehicle functionality.
Please note that the ignition switch
and the electrical appliance have
been turned o when installing the
battery.
NOTE
Battery needs to dimensionally
OK, to avoid terminals fouling with
Battery Tray.
!
The used battery should not be
discarded at will, for it is harmful to
the environment. It must be recycled
by approved agencies. Please
consult JSW MG authorised service
center for more details.
V e h i c l e M a i n t e n a n c e
5
MAINTENANCE
5-18
Battery installation
Turn o the ignition switch and all
electrical appliance before removing
the battery.
Place the battery in the mounting
position and secure it with battery
bracket.
Secure the positive cable then the
negative one, then energize the
battery.
NOTE
The JSW MG MOTOR shall not be
liable/responsible for any
damages / injuries, including
consequential damages/injuries,
resulting due to fitment of non
OEM approved batteries.
!
CAUTION
To avoid battery discharge, please
turn o the ignition switch when
leaving the vehicle.