2
If the brake system warning lamp
illuminates after the park brake is
fully released, it indicates possibility
that the brake fluid level in the fluid
reservoir is too low or an EBD system
fault has occurred.
In this case, please operate in the
following steps:
1. Carefully drive the vehicle o the
lane and then stop the vehicle.
2. Check the brake fluid level.
3. Add the recommended brake
fluid until the fluid level reaches
MAX (highest) mark.
CAUTION
Please do not drive the vehicle
when the brake system warning
lamp has illuminated.
This indicates that the brake may
not work normally.
Driving the vehicle with a brake
fault can lead to a collision,
causing personal injuries and
damage to the vehicle or other
properties as a result.
S a f e t y S y s t e m s
2-32
BRAKE SYSTEM
4. In case of the following
circumstances, it is
recommended to drive the
vehicle at a safe speed to the
nearest JSW MG authorised
Service Center to inspect the
brake and confirm that:
• You discovered the brake
system leakage.
• The brake system warning
lamp keeps illuminated.
• The brake cannot work
normally.
To Next Page
Loading...
