3
3-27
S t a r t i n g y o u r E V
Loss of keys
If one of the keys is lost, contact the
JSW MG authorised service center
immediately.
Signal transmission autostop
function of remote control
The remote control has the signal
transmission auto stop function
which can prevent unnecessary
battery loss caused by mis operation
and other reasons.
Long press any button on the remote
control for over 20s, the remote
control will stop transmitting signals
automatically. And release the
button, the signal transmission
autostop function is deactivated.
Fault
If the remote control cannot function
normally, it may be caused by the
following reasons:
• Out of remote control working
range;
• Excessively low SOC of remote
control battery;
• Interference by external
environment and other high-
power radio signals (such as
base station and launch tower);
• Signal blocking by other barriers.
OPENING & CLOSING
NOTE
To ensure normal functioning of
the remote-control key, please
follow the following rules:
• Avoid dropping the remote-
control key.
• Please do not place a heavy
object on the remote-control
key.
• Make sure the remote-control
key is away from water or direct
sunlight. If the remote-control
key is socked, please wipe it
with a soft cloth.
!
To Next Page
Loading...
