SLIMLINE touch (EN)_allgem. Vers.01 (02-2022→) Translation of the original Page 47-47
7.3 RECOMMENDED MAINTENANCE INTERVALS
The moving parts of the device are maintenance free. The bearings are sealed-for-life. We
recommend the following intervals for testing specific parts:
Cut result, damage to knife
Feed carriage and slice support
Damage and freedom of
movement
Toothed belts, chains, etc.
8 REPAIRS
9 FINAL DECOMMISSIONING AND DISPOSAL
Final decommissioning and disposal requires the machine to be dismantled into its individual
components.
• Switch off the machine and secure it against being switched on again.
• Disconnect the entire power supply to the machine.
• Discharge residual energy and check that no voltage is present
Dispose of all parts of the machine in such a way that damage to health and the environment is
excluded.
Before disposal, check the environmental risks that may occur.
• Disposal must be carried out in accordance with the applicable regulations of the
respective country.
• If you have any questions about disposal, contact the manufacturer, the local authorities
or specialist disposal companies.
• During all work, comply with the legal regulations on waste avoidance and proper
recycling and disposal.
• Dispose of electrical waste properly
• Scrap metal parts
• Recycle plastic parts
• Dispose of lubricants and other auxiliary materials properly.
Repair work may only be completed by MHS or technical companies
approved by MHS!
To Previous Page