EasyManua.ls Logo

MHS Boilers SLIMLINE touch - Information for Trained Operating Personnel

MHS Boilers SLIMLINE touch
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SLIMLINE touch (EN)_allgem. Vers.01 (02-2022→) Translation of the original Page 8-47
Non-ionising radiation is not produced directly, but rather emitted only
due to the technology of the electrical operating equipment (e.g. by
electrical motors, power lines, or magnetic coils).
The machine also does not possess strong permanent magnets.
If the safety clearance (clearance of field source from implant) of 30 cm
is maintained, the influence on active implant (e.g. heart pacemakers,
defibrillators) may be ruled out with high probability.
Maintenance personnel must be qualified to work in their assigned area and role, and must
undergo regular training. This operating and maintenance manual may be used as the basis for
such training.
No modifications may be carried out on the safety devices during care
or maintenance work. As far as possible, care and maintenance work
may only be performed on the machine if it is switched off and secured
against unauthorised reactivation. Remove the mains plug!
When work is being performed on the unit's electrical system, the unit must be
additionally checked for zero potential.
After care and maintenance work are complete, any protective covers which have been
removed or opened must be set back in their original position.
The machine may only be used in a technically sound condition, in the
proper manner, with the appropriate awareness of safety and any
hazards, and in following the Operating and Maintenance Manual.
In particular, faults that could impair the safety must be corrected immediately.
2.2.2 Information for trained operating personnel:
Passwords or tools for opening the safety guards must not be kept visibly near the
machine.
After cleaning the machine, make sure that all of the machine's protective devices are
closed.
If the machine has been used to cut products containing liquids or toxic substances, it
must be cleaned. If necessary, have the machine checked by a service technician for
risks such as electric shocks, fire hazards and health risks before putting it back into
operation.