SLIMLINE touch (EN)_allgem. Vers.01 (02-2022→) Translation of the original Page 6-47
1.3 RESIDUAL RISKS
The machine has been built in accordance with the specifications set out in the Machinery
Directive. However, the following residual risks remain:
- Risk of cuts in the event of contact with the blade.
- Risk of crushing by the flap.
- Contamination of the sliced product due to deficient cleaning
1.4 COPYRIGHT
The contents of this operating manual in all its parts shall remain the property of MHS
Schneidetechnik GmbH. Reproduction, even extracts thereof, shall require our approval.
2 Safety and safety equipment
2.1 SAFETY SYMBOLS
This symbol is used in this Operating and Maintenance Manual in all
work safety instructions where there is a risk to life and limb of
persons. Please pay attention to this information and take special care.
Provide all work safety instructions to other users as well.
This symbol is used in this Operating and Maintenance Manual in all
work safety instructions where there is a risk to life and limb of
persons resulting from electric shocks. Mortal danger!
ATTENTION!
This prompt is specified in the Operating and Maintenance Manual to
highlight information which is to be observed in order to maintain the
guidelines, regulations, notes and correct sequence of work as well as
to prevent potential damage or loss of the machine / system.
NOTE!
This note is provided in sections of the Operating and Maintenance
Manual where special details are provided relating to the economic use
of the machine / system and where technical requirements are to be
met which the user should pay special attention to.
To Next Page
Loading...